Morse Lens

Guide

How to read morse code from a blinking light.

By eye, or let the camera do it.

The quick way.

Open the light decoder and point your phone at the light. It finds the flashes, works out the speed and writes the message. In our tests a 30 fps phone camera read 99.7% of characters at 15 words per minute.

Open the light decoder

Reading it by eye.

  1. Find the rhythm first. Watch a few flashes and settle on what a short one looks like. Everything else is measured against it.
  2. Short flash is a dot. A flash three times as long is a dash.
  3. A short dark gap keeps you inside a letter. A longer gap, about one dash, ends the letter.
  4. A much longer pause, about seven dots, ends the word.
  5. Write the dots and dashes down as they come. Look the letters up afterwards in the alphabet chart.

How to know when a letter ends.

Only by the gap. Morse has no end-of-letter mark, so the sender's pauses carry the meaning. Hand-sent signals drift, which is why beginners lose letters at the gaps and not at the flashes. Compare each gap to the last dash you saw: shorter means same letter, about equal means next letter.

Common mistakes.

  • Decoding in your head while watching. Write first, translate later.
  • Missing the first letter. The message often repeats, so wait for the second pass.
  • Reading afterglow as a dash. Old bulbs fade slowly. Judge by when the light comes on, not when it is fully dark.
  • Standing too close to a bright torch. Glare makes every flash look long.

Signals worth knowing by sight.

  • SOS: three short, three long, three short, with no letter gaps. See SOS in morse code.
  • A single long flash, repeated: often "T" or simply "attention".
  • Sending back? The translator flashes any message with your screen or phone flashlight.

More ways to morse.

Questions.

How fast is flashlight morse usually sent?

By hand, 5 to 10 words per minute. A dot is then 120 to 240 ms long.

Can a phone read morse from a light?

Yes. The Morse Lens light decoder reads it live in the browser, and the iPhone app does the same.

What if the light is recorded in a video?

Use the video decoder. It reads uploaded clips and pasted links from YouTube, TikTok, Reddit and other sites.